6018

Verlustreduziertes Netzgerät in automatischer 3-Stufen-Technik mit Power-MOS-Gleichrichter und Spannungsverdopplung max. 2A bis 10V, 1A bis 20V, 0,6A bis 29V

Verlustleistungsreduziertes analoges Netzgerät in automatischer 3-Stufen-Technik mit einer Ausgangsspannung
 
Je 1 DVM für die Ausgangsspannung und den Ausgangsstrom, 1mA oder 2mA
 
Maximale Ausgangsströme: 
2A bis 10V, 1A bis 20V und 0,6A bis 29V
(0,3A bis 12V, 24V, 31V) 
 
Zusatz Poti Pz zum exakten Regeln kleiner Ausgangsspannungen 
 
Große Lade Elkos
Ausnützen der Leerlaufspannungen
Minimaler Spannungsabfall an der Regelstrecke
 
Rippelspannung jeweils kleiner 7mV Spitze/Tal bei max. Ausgangsströmen
 
Warn-LED bei Annäherung der Ausgangsspannung an die Betriebsspannung (ge)
Strom-Peak-LED 
 
Damit auf die Platine keine Netzspannung geführt werden muss, haben die beiden Print-Trafos für die Digitalvoltmeter vertauschte Windungen.
 
Selbstverständlich ist ein selbst gebautes Netzgerät viel teurer als ein fertig Gekauftes, aber es bringt Lernen und Freude.
 
Vor dem ersten Einschalten des Netzgerätes hat sich ohne ICs eine genaue Prüfung sämtlicher Bauteilverbindungen mit dem Ohmmeter bewährt. So erspart man sich stunden- oder tagelange Fehlersuche.
 
 
EN
 

Low-dissipation analog power supply using automatic 3-stage technology, with a single output voltage

  • One DVM each for output voltage and output current, 1 mA or 2 mA
  • Maximum output currents: 2 A up to 10 V, 1 A up to 20 V, and 0.6 A up to 29 V (0.3 A up to 12 V, 24 V, 31 V)
  • Additional potentiometer Pz for precise adjustment of low output voltages
  • Large smoothing (reservoir) electrolytic capacitors
  • Makes full use of the no-load voltages
  • Minimal voltage drop across the regulating element
  • Ripple voltage below 7 mV peak-to-trough in each case at maximum output currents
  • Warning LED when the output voltage approaches the supply voltage (yellow)
  • Current-peak LED
 

So that no mains voltage has to be routed onto the PCB, the two PCB-mount transformers for the digital voltmeters have their windings reversed (primary and secondary swapped).

Naturally, a self-built power supply is far more expensive than a ready-made one, but it brings learning and enjoyment.

Before switching the power supply on for the first time, it has proven worthwhile to check all component connections carefully with an ohmmeter, with the ICs not yet fitted. This saves you hours or days of fault-finding.